This website uses cookies, which are necessary for the technical operation of the site and which are always set. In order to further improve our offer and our website, we would like to set additional cookies in order to collect anonymized data for statistics and analyzes. However, these are only set with your consent. Further information on cookies can be found in our privacy policy.

Privacy policy Acceptdone
    PCB-357A100
    zoom_out_map

      PCB-357A100

      • Vibration sensor with charge output,
      • Continuous use temperature up to 482 ° C,
      • With UHT-12™ sensor element,
        (no popcorn noise),
      • Measuring range 200 g,
      • Sensitivity 5 pC/g,
      • Upper cutoff frequency 5,000 Hz,
      • 2-pin female connector on the side
      Specifications
      Basic dataEnglish unitsSI units 
      Sensitivity (≤5 %)5.0 pC/g0,510 pC/(m/s²) 
      Measuring range±200 g pk±1.962 m/s² pk 
      Frequency range (+ 10%)5.000 Hz[3]
      Resonance frequency20,000 Hz[1]
      Linearity error≤1 %[4]
      Transverse acceleration sensitivity≤5 %[2]
      Conditions of use
      Overload limit (shock)±1.000 g pk±9.810 m/s² pk 
      Temperature range-65... 900 ° F-54... 482 ° C 
      Technical characteristics
      capacity (from pin to pin)120 pF[1]
      capacity (by pin housing)≤2 pF[1]
      capacity
      (Asymmetry between the pins)      		≤2 pF 
      ISOlationswiderstand
      (von Pin auf Gehäuse bei 21 °C)      		> 1,000 MΩ[1]
      ISO Lationswiderstand
      (von Pin auf Pin bei 21 °C)      		> 1,000 MΩ 
      ISO Lationswiderstand
      ( from pin to pin at 482 ° C)      		> 100 k Ω 
      physical properties
      sensor elementUHT-12™ 
      geometry of the sensor elementshear principle 
      Housing materialInconel 
      sealinghermetically sealed 
      size - height0.75 in19 mm 
      size -. Diameter1.5 in38.1 mm 
      size - length1.88 in47.8 mm 
      mass2.32 oz65.8 g[1]
      electrical connection7/16-27 2-pin 
      Connection positionside 
      mounting3 holes 
      notes
      [1]typeischerweise  
      [2]Transverse acceleration sensitivity typically ≤3%  
      [3]The lower cut-off frequency depends on the used signal conditioning electronics.  
      [4]Zero-balance just, determined using the method of least squares  
      Included accessories
      081A99Mounting screws(3)
      ICS-8Frequency response calibration of 600 cpm (10 Hz) up to the upper 10% frequency.(1)
      PCB-357A100

      Specific References