PCB-054222-01274
basic data | |||
measurement range | 60.701 lb | 270 kN | [2] |
factor | 1,50 mV / V | [1] [2] | |
Linearitä avoidable | ±5% FS | [1] | |
hysteresis | ±5% FS | [1] | |
repeatability | ±2% FS | [1] | |
Resonance frequency | of10,000 Hz | ||
conditions of use | |||
Overload limit | 91.050 lb | 405 kN | |
Temperature range (operation) | 0 …200 °F | 18 … 93 ° C | |
Temperature range (offset) | not specified | ||
influence of temperature on the output signal (maximum) | ±0, 02% of measured value / ° F | ±0. 036% of reading / ° C | [3] |
temperature influence on (max) zero signal | deviation/±0, 02% FS / ° | F/±0, 036% FS / ° C | [1] |
technical Properties | |||
Bridge resistance | 350 Ω | [2] | |
supply voltage (recommended) | 10 V DC | [4] | |
output polarity | positive | ||
physical properties | |||
size - diameter | 1,888 in | 47,95 mm | |
Size - height | 0.665 in | 16.89 mm | |
screw diameter | 0,866 in | 22.00 mm | |
Through hole diameter | 0,872 in | 22.16 mm | |
sensor element | strain | ||
wiring | Tinned ends | ||
cable exit | side | ||
notes | |||
[1] | FS = "Full Scale": full scale | ||
[2] | nominal | ||
[3] | over the compensated temperature range | ||
[4] | calibrated 10 v DC supply voltage; Power supply with 5 … 20 V DC or V AC RMS possible |