PCB-054220-01224
zoom_out_map

PCB-054220-01224

  • DMS miniature measuring washer
    for the measurement of static forces,
  • Screw diameter 20 mm,
  • Range 220 kN,
  • Nominal 1.5 mV / V,.
  • Integrated cable, length 1.5 m,
    ending on open ends
of
basic data
measurement range 49.458 lb 220 kN [2]
factor 1,50 mV / V [1] [2]
Linearitä avoidable ±5% FS [1]
hysteresis ±5% FS [1]
repeatability ±2% FS [1]
Resonance frequency10,000 Hz
conditions of use
Overload limit 74.187 lb 330 kN
Temperature range (operation) 0 …200 °F 18 … 93 ° C
Temperature range (offset) not specified
influence of temperature on the output signal (maximum) ±0, 02% of measured value / ° F ±0. 036% of reading / ° C [3]
temperature influence on (max) zero signal deviation/±0, 02% FS / ° F/±0, 036% FS / ° C [1]
technical Properties
Bridge resistance 350 Ω [2]
supply voltage (recommended) 10 V DC [4]
output polarity positive
physical properties
size - diameter 1.62 in 41.1 mm
Size - height 0,595 in 15.1 mm
screw diameter 0,787 in 20 mm
Diameter of the bore hole 0,794 in 20,16 mm
sensor element strain
wiring Tinned ends
cable exit side
notes
[1] FS = "Full Scale": full scale
[2] nominal
[3] over the compensated temperature range
[4] calibrated 10 v DC supply voltage; Power supply with 5 … 20 V DC or V AC RMS possible
PCB-054220-01224

Specific References

Download

0542xx-01xxx_drawing.pdf

Technical drawing

Download (466.12k)

054220-01224_manual.pdf

Operating instructions

Download (422.65k)

054220-01224_specs.pdf

Technical data sheet

Download (13.42k)