PCB-054218-01184
- DMS miniature measuring washer
for the measurement of static forces, - Screw diameter 18 mm,.
- Range 180 kN,
- Nominal 1.5 mV / V,.
- Integrated cable, length 1.5 m,
ending on open ends
| basic data | |||
| measurement range | 40.465 lb | 180 kN | [2] |
| factor | 1,50 mV / V | [1] [2] | |
| Linearitä avoidable | ±5% FS | [1] | |
| hysteresis | ±5% FS | [1] | |
| repeatability | ±2% FS | [1] | |
| Resonance frequency | 10,000 Hz | ||
| conditions of use | |||
| Overload limit | 60.698 lb | 270 kN | |
| Temperature range (operation) | 0 …200 °F | 18 … 93 ° C | |
| Temperature range (offset) | not specified | ||
| influence of temperature on the output signal (maximum) | ±0, 02% of measured value / ° F | ±0. 036% of reading / ° C | [3] |
| temperature influence on (max) zero signal | deviation/±0, 02% FS / ° | F/±0, 036% FS / ° C | [1] |
| technical Properties | |||
| Bridge resistance | 350Ω | [2] | |
| supply voltage (recommended) | 10 V DC | [4] | |
| output polarity | positive | ||
| physical properties | |||
| size - diameter | 1.62 in | 41.1 mm | |
| Size - height | 0,595 in | 15.1 mm | |
| screw diameter | 0,709 in | 18 mm | |
| Through hole diameter | 0,715 in | 18.16 mm | |
| sensor element | strain | ||
| wiring | Tinned ends | ||
| cable exit | side | ||
| notes | |||
| [1] | FS = "Full Scale": full scale | ||
| [2] | nominal | ||
| [3] | over the compensated temperature range | ||
| [4] | calibrated 10 v DC supply voltage; Power supply with 5 … 20 V DC or V AC RMS possible |
PCB-054218-01184
