PCB-EX615A42
- Vibration sensor with charge output,
- With ATEX approval,
- Continuous use temperature up to 260 ° C,
- With through-holes
- Measuring range 200 g,
- Sensitivity 100 pC/g,
- Upper frequency limit 6,000 Hz,
- Integrated armored PTFE - cable, length 3 m,
ending on tinned ends
| specifications | |||
|---|---|---|---|
| basic data | English units | SI units | |
| Sensitivity (± 5%) | 100 pC / g | 10.2 pC / (m / s) | [1] |
| measuring range | ± 200 g pk | ± 2,000 m / s² pk | |
| Upper limit frequency (± 5%) | 5000 Hz | [6] | |
| Upper limit frequency (± 10%) | 6000 Hz | ||
| resonant frequency | > 20,000 Hz | [2] [3] | |
| Linearity error (<200 g pk) | ± 1% | [4] | |
| Lateral acceleration sensitivity | <5% | [5] | |
| Operating conditions | |||
| Overload limit (shock) | 1.000 g pk | 9800 m / s pk | |
| temperature range | -65 ... 500 ° F | -54 ... 260 ° C | |
| temperature coefficient | 0.03% / ° F | 0.06% / ° C | [3] |
| Strain sensitivity (base surface) | 0.003 g / µε | 0.03 (m / s²) / µε | [3] |
| protection | IP68 | ||
| Technical Specifications | |||
| Capacity (from pin to pin) | 11,100 pF | [3] | |
| Capacity (integrated cable) | 35 pF / ft | 115 pF / m | |
| Insulation resistance (at room temperature) | ?1.000 MΩ | ||
| Electrical insulation (housing) | > 100 M | ||
| physical properties | |||
| sensor element | ceramics | ||
| Geometry of the sensor element | shear principle | ||
| housing material | stainless steel | ||
| seal | Hermetically sealed | ||
| Size - Height | 0.89 in | 23 mm | |
| Size - Length | 1.58 in | 40 mm | |
| Size - Width | 1.58 in | 40 mm | |
| Weight (without cable) | 6.7 oz | 190 grams | [3] |
| Assembly | With four through bolts | ||
| cable length | 10 ft | 3 m | |
| cable termination | tinned | ||
| cable type | Armored 3-wire cable PTFE | ||
| mounting torque | 11 ft-lb | 15 Nm | |
| Hints | |||
|---|---|---|---|
| [1] | Conversion factor 1 g = 9,81 m / s² | ||
| [2] | 24 kHz nominal | ||
| [3] | typically, | ||
| [4] | Zero-based line of best fit, determined by the method of least squares | ||
| [5] | Lateral acceleration sensitivity typically ≤ 3% | ||
| [6] | 1 Hz = 60 cpm ( "Cycles Per min": revolutions per minute) | ||
| included supply | ||
|---|---|---|
| 081C108 | Mounting screw, 1/4 "-28x1, Inconel | (2) |
| ICS-1 | Calibration frequency response of 10 Hz to the upper 5% -frequency | (3) |
PCB-EX615A42
