PCB-422E52
| basic data | |||
| transcription factor (±2. 5%) | 10 mV/pC | ||
| entrance | ±500 pC | ||
| Range | ±8 V | ||
| Lower limiting frequency (-5%) | 5 Hz | ||
| upper cut-off frequency (-5%) | 100,000 Hz | [2] | |
| linearity error | 1.0% FS | ||
| conditions of use | |||
| temperature range (operation) | -65 … 250 ° F | -54 … 121 ° C | |
| maximum Shock resistance | 5,000 g pk | 49,050 m/s² pk | |
| maximum acceleration (5) | 100 g pk | 981 m/s² pk | |
| technical | |||
| power supply | 18 … 28 V DC | ||
| constant power supply | 2 … 20 mA | ||
| Output area | ±5, 0 V | ||
| output impedance | 100 Ω | ||
| Bias voltage | 9 … 13 V DC | ||
| Maximum sensor input voltage | of40 V | ||
| wide band noise (1 … 10,000 Hz) | 33 µV | -90 dB | [1] |
| Spectral noise (1 Hz) | 9.8 µV / √ Hz | -100 dB | [1] |
| spectral noise (10 Hz) | 3 µV / √ Hz | -110 dB | [1] |
| Spectral noise (100 Hz) | 0.8 µV / √ Hz | -122 dB | [1] |
| spectral noise (1,000 Hz) | 0.4 µV / √ Hz | -128 dB | [1] |
| Spectral noise (10,000 Hz) | 0.2 MV / √ Hz | -134 dB | [1] |
| capacity (feedback branch of the amplifier) | 100 pF | ||
| Recovery time after clipping | 10 µs | ||
| discharging charging time constant | > 0.1 s | ||
| Resistance (feedback branch of the amplifier) | 48,000 M Ω | [3] | |
| influence of the input capacitance (sensor + cable) on transcription factor | 0.00≤5 %/pF | ||
| Physical properties | |||
| housing material | stainless steel | ||
| waterproofing | epoxy resin | ||
| Electrical connection (input) | 10-32-coaxial socket | ||
| electrical connection (output) | BNC Plug | ||
| Gr öße - diameter | 0.52 in | 13 mm | |
| size - length | 3.4 in | 86 mm | |
| mass | 1.15 oz | 32.7 grams | |
| Notes | |||
| [1] | tested with a voltage source and a capacitor (to simulate of a sensor) | ||
| [2] | the upper cutoff frequency can be reduced by the amount of constant current and the length of the cable output used. | ||
| [3] | ways of amplifier electronics coming to the use of must discharge charge time constantbe calculated on the basis of three times the resistance value in the feedback industry. | ||
| [4] | details: see PCBs Declaration of conformance PS024. CE conformity is only guaranteed, if the housing is earthed. |
PCB-422E52
