PCB-355M73
Miniature ring-style, ceramic shear ICP® accel., 100 mV/g, 7 to 10k Hz, integral waterproof cable, 20-ft twisted shielded pair to pigtails, case isolated
Waterproof, pressure tested cables over-molded directly to the sensor- Sensitivity: (±10%)100 mV/g (10.2 mV/(m/s²))
- Measurement Range: ±50 g pk (±491 m/s² pk)
- Broadband Resolution: 0.001 g rms (0.01 m/s² rms)
- Frequency Range: (±5%)7 to 9000 Hz
- Sensing Element: Ceramic
- Weight: .13 oz (3.6 gm)
Specification Notes
[1] Zero-based, least-squares, straight line method.
[2] Typical.
[3] Sensor with Cable is hydrotested from 0 to 600 psi (4.0 MPa) for 5 cycles and then held at 600 psi for 30 minutes during a sixth cycle.
| English: | SI: | ||
|---|---|---|---|
| Performance | |||
| Sensitivity (±10 %) | 100 mV/g | 10.2 mV/(m/s²) | |
| Measurement Range | ±50 g pk | ±491 m/s² pk | |
| Frequency Range (±5 %) | 7 to 9000 Hz | 7 to 9000 Hz | |
| Frequency Range (±10 %) | 5 to 11000 Hz | 5 to 11000 Hz | |
| Frequency Range (±3 dB) | 3 to 20000 Hz | 3 to 20000 Hz | |
| Resonant Frequency | ≥45 kHz | ≥45 kHz | |
| Broadband Resolution (500) | 0.001 g rms | 0.01 m/s² rms | [2] |
| Non-Linearity | ≤1 % | ≤1 % | [1] |
| Transverse Sensitivity | ≤5 % | ≤5 % | |
| Environmental | |||
| Overload Limit | ±5000 g pk | ±49050 m/s² pk | |
| Temperature Range | -65 to +175 °F | -54 to +79 °C | |
| Base Strain Sensitivity | 0.008 g/µε | 0.08 (m/s²)/µε | [2] |
| Electrical | |||
| Excitation Voltage | 20 to 30 VDC | 20 to 30 VDC | |
| Constant Current Excitation | 2 to 20 mA | 2 to 20 mA | |
| Output Impedance | ≤300 Ohm | ≤300 Ohm | |
| Output Bias Voltage | 8 to 12 VDC | 8 to 12 VDC | |
| Discharge Time Constant | 0.07 to 1.0 sec | 0.07 to 1.0 sec | |
| Settling Time (within 10% of bias) | <5 sec | <5 sec | |
| Spectral Noise (1 kHz) | 4.5 µg/√Hz | 25 (µm/sec2)/√Hz | [2] |
| Spectral Noise (10 kHz) | 2.5 µg/√Hz | 20 (µm/sec2)/√Hz | [2] |
| Electrical Isolation (Case) | ≥100000000 Ohm | ≥100000000 Ohm | |
| Physical | |||
| Size - Height | .32 in | 8.1 | |
| Size - Length | 1.10 in | 27.9 mm | |
| Size - Width | 0.46 in | 11.7 mm | |
| Weight (without cable) | .13 oz | 3.6 gm | [2] |
| Sensing Element | Ceramic | Ceramic | |
| Sensing Geometry | Shear | Shear | |
| Housing Material | Titanium | Titanium | |
| Sealing | Hermetic | Hermetic | [3] |
| Electrical Connector | Sealed Integral Cable | Sealed Integral Cable | |
| Electrical Connection Position | Side | Side | |
| Cable Termination | Pigtail Ends | Pigtail Ends | |
| Cable Length | 20.0 ft | 6.1 m | |
| Mounting | Through Hole | Through Hole | |
| Mounting Torque | 1 to 2 in-lb | 11 to 23 N-cm | |
* All specifications are at room temperature unless otherwise specified.
Accessories
| Supplied | ||
| 100-8002-20 | 1 | |
| 37642-01 | 1 | |
| ACS-1 | Single axis amplitude response calibration from 10 Hz to upper 5% frequency, NIST traceable | 1 |
| ACS-139 | 1 | |
PCB-355M73
