Cable for MEMS sensors

Cable for MEMS sensors

Application-specific cabling is an essential part of every measuring chain. Application, environmental conditions and the measurement or monitoring system require special cables or connection configurations. In addition to the standard cables shown here, Piezotronics also offers a wide range of cables that are tailored to specific tasks.

Showing 1-9 of 9 item(s)
Showing 1-9 of 9 item(s)

Active filters

PCB-037P10

  • 10-conductor Teflon shielded,
  • 3 meters,
  • 9-pin connector on the open ends,
  • stripped and tinned

    PCB-037P20

  • 10-conductor Teflon shielded,
  • Length 6 meters
  • 9-pin connector on the open ends,
  • stripped and tinned

    PCB-037P30

  • 10-conductor Teflon shielded,
  • Length 9 meters
  • 9-pin connector on the open ends,
  • stripped and tinned

    PCB-037P05

  • 10-conductor Teflon shielded,
  • Length 1.5 m,
  • 9-pin plug on end of cut

    PCB-010P50

  • Four-wire Teflon shielded,
  • Length 15 m,
  • 4-pin plug on open ends,
  • stripped and tinned

    PCB-010P20

  • Four-wire Teflon shielded,
  • Length 6 meters
  • 4-pin plug on open ends,
  • stripped and tinned

    PCB-010P30

  • Four-wire Teflon shielded,
  • Length 9 meters
  • 4-pin plug on open ends,
  • stripped and tinned

    PCB-010P05

  • Four-wire Teflon shielded,
  • Length 1.5 m,
  • 4-pin plug on open ends,
  • stripped and tinned

    PCB-010P10

  • Four-wire Teflon shielded,
  • 3 meters,
  • 4-pin plug on open ends,
  • stripped and tinned