PCB-426E01
| basic data | |||
| Nominal diameter of microphone | 1/2 " | ||
| gain | -0.05 dB | [1] [2] | |
| Frequency range (±0. 1 dB) (rel. 1,000 Hz) | 6.3 … 125,000 Hz | ||
| Frequency range (-3 dB) (rel. 1,000 Hz) | < 0.9 Hz | ||
| frequency range with phase deviation-1 … 1 ° | 32 … 20,000 Hz | [1] | |
| frequency range with phase deviation-1 … 10 ° | 3.2 … 32 Hz | [1] | |
| noise (A-weighted) | < 2.8 µV | [1] | |
| noise (A-weighted) | 1.7 MV | [1] [2] | |
| noise (unweighted, 20 … 20,000 Hz) | < 5 µV | [1] | |
| Noise (unweighted, 20 … 20,000 Hz) | 3 µV | [1] [2] | |
| distortion (input 3 V rms at 1,000 Hz) | ≤ 70 dB | [1] | |
| Rate of change of the output | 2 V/µS | [2] | |
| TEDS Chip | by defaultintegrated | [3] | |
| conditions | |||
| temperature range (operation) | -40 … 176 ° F | -40 … 80 ° C | |
| temperature influence | < 0.05 dB | ||
| air humidity (non-condensing) | 0 … 95% RH | ||
| influence by humidity | < 0.05 dB | ||
| Specifications | |||
| power supply | 20 … 32 V DC | ||
| Constant power supply | 2 … 20 mA | ||
| impedance (input) | 20 G Ω | [2] | |
| capacity (input) | 0.06 pF | [2] | |
| Bias voltage | 10 … 14 V DC | ||
| impedance (output) | < 50 Ω | ||
| Output range (maximum) | ±7 V pk | ||
| physical properties | |||
| parts usematerial | stainless steel | ||
| Size - diameter | 0.5 in | 12.7 mm | |
| size - length | 3.18 in | 80.7 mm | |
| mass | 1.35 oz | 38 g | |
| Connector | BNC Jack | ||
| thread for microphone | 0,4606 - 60 UNS | 11,7 mm - 60 UNS | |
| Notes | |||
| [1] | measured with a reference microphone with 18 pF | ||
| [2] | typically | ||
| [3] | TEDS memory in accordance with IEEE PP1451. 4 | ||
| [4] | details: see PCBs Declaration of conformance PS064 | ||
| supplied accessories ör | |||
| ERC-16 | calibration of a microphone preamplifier | -1 |
PCB-426E01
