PCB-3741B1250G
basic data | |||
sensitivity (±5%) | 40 mV / g | 4.1 mV/(m/s²) | [1] |
range | ±50 g pk | ±490, 3 m/s 2 pk | |
frequency range (±5%) | 0 … 1,000 Hz | ||
Frequency range (±10) | 0 … 1500 Hz | ||
Resonance frequency | > 5,100 Hz | ||
phase shift (100 Hz) | < 10 ° | ||
wide band resolution | 5.2 mg rms | 0.05 m/s² RMS | [2] |
linearity | ≤ 1% FS | [3] | |
Transverse acceleration sensitivity | ≤ 3% | ||
conditions of use | |||
Overload limit (shock) | ±3. 000 g pk | ±29. 420 m/s² pk | |
temperature range (operation) | -65 … 250 ° F | -54.0 … 121 ° C | |
temperature range (storage) | -65 … 250 ° F | -54.0 … 121 ° C | |
Temperature coefficient of sensitivity the zero point | ±2, 0% FSO | [4] [5] | |
strain sensitivity (footprint) | 0.0002 g/µε | 0.002 (m/s²)/µε | [2] |
technical characteristics | |||
Supply | 6 … 30 V DC | ||
power | &le≤6 mA | ||
Output impedance | ≤ 100 Ω | ||
Spannungsoffset | ± 40 mV DC | [6] | |
spectral noise (1) | 580 µg /. √ Hz | 5.688 (µm / s ²) / √ Hz | [2] |
electrical insulation (housing) | ≥ 100 MΩ | [7] | |
physical properties | |||
Housing material | Anodized aluminium | ||
Waterproofing | epoxy resin | ||
great & fun; s height | 0.30 in | 7.62 mm | |
size - length | 1.00 in | 25.4 mm | |
size - width | 0.85 in | 21,6 mm | |
dimensions (without cable) | 0.35 oz | 9.92 grams | [2] |
electrical connection | integrated cable | ||
Cable exit | side | ||
Cable termination | tinned ends | ||
cord type | type 010, 4-wire shielded cable | ||
cable length | 10 ft | 3 m | |
Mounting | two mounting holes | ||
notes | |||
[1] | measured at 100 Hz, 10 g RMS | ||
[2] | typically | ||
[3] | zero-based balancing line, determined using the method of least squares | ||
[4] | FSO = "Full Scale Output": maximum output signal of the measuring range (4 V D)C). | ||
[5] | -54 … 121 ° C, reference 24 ° C | ||
[6] | Offset tolerance for standard cable length (3 m) | ||
[7] | between housing/cable shielding and mounting surface or wire | ||
[8] | details: see PCB Declaration of Conformance PS027 | ||
Optional accessory | |||
080A208 | triaxial mounting cube | -1 | |
equipment | |||
081A103 | mounting screw | 2 | |
ACS-103 | calibration of amplitude and phase response of 2 Hz up to the upper 5% frequency | -1 | |
M081A103 | mounting screw and Washer, threaded M3 x 0.5 | 2 |