Signal Conditioning
.
Sort by:
Inline charge amplifier for high-temperature sensors, Input range ±2. 500 pC, Output range ±2, 5 V, Transcription factor: 1 mV / pC, Frequency range 5 … 100,000 Hz (depends on the constant current)
PCB-480B21
- Battery powered 3-channel-supply unit,
- Inputs: ICP®,
- Amplification factors 1 x, 10 x and 100 x,
- BNC-inputs and outputs and alternate 4-pin input for Triax-sensor
Digital ICP - USB Signal Conditioner
- Easily save and share data on-the-go
- Plug & play signal conditioning
- Makes high quality measurement more accessible
- Pocket-sized, USB powered, portable signal conditioning
- Analysis options from time domain to RMS to FFT and more
- Simplifies measurement chain without sacrificing quality
- No driver installation required
Portable 3-channel IEPE-signal amplifiers
The PA-3000 is a portable three-channel IEPE signal conditioners.
2 channel 24 bit USB-measured value acquisition
RogaDAQ2 is measuring technology for direct via USB on the go in the notebook p >
VibMobile mobile multi-channel frontend
- Portable, for use on site and in the laboratory, li >
- up to 64 analog input channels (kHz 24-bit @ 204.8), li >
- Battery (opt.), low-noise operation, li >
- 2 analog outputs, 2 speedometer inputs, 4/4 digital I/O in the base system,
- Bridge module with 8 input channels,
- Built-in CPU i7 (embedded win 7).
- Stand-alone or front-end operations.
- 12 slots for 8 I/O cards from m + p and to 4 CompactPCI < sup >® sup > Cards
PCB-482C24
PCB-482C26
PCB-482C27
PCB-482C54
- 4-channel power supply unit,
- Inputs: ICP®, voltage and load,
- Continuous gain of 0.1 … 200x,
- BNC-inputs and outputs,
- TEDS Support,
- Including power supply